The Pryda range of Stud to Wall Plate Screws for Prefabricated Frames provides a certified design used in conjunction with the Pryda Design Software.

SMARTER DESIGN

  • Standard 5mm hex drive which is available throughout Australia and New Zealand
  • A deeper drive recess to improve driver life span
  • Unique Buildex designed screw tip giving a rapid start and reduced splitting
  • Coarse thread which significantly decreases driving time
  • Pronounced knurl that lessens any splitting of the ends of wall plates

PROVEN ENGINEERING

  • Pryda Screws have been laboratory tested for Stud to Wall Plate connections
  • Use of the Pryda Screw with Pryda Design Software provides a Certified Design

EASIER IDENTIFICATION

  • All screws are head stamped to ensure quality and instant identification
  • Every application certified by “first principles” structural design software
  • Frames using the Pryda Screws are all labelled and detailed certification is available

GREATER CAPACITY

  • Increased thread length to give greater capacity
  • The capacity is greater than most flat metal stud ties
  • 2 screws can be used in a 90mm stud where only 1 conventional stud tie is possible
  • Screws can replace conventional stud ties used within bracing units
Pryda Screws for Stud to Wall Plate Connections
Pry

PRYDA SCREWS PROVIDE A QUICKER, SAFER & STRONGER SOLUTION THAN EXISTING STUD TIES

Single 150 Screw Double Top Plate Complete With Truss And Std - Stud to Wall Plate Connection

Pryda Screw used with standard MultiGrip

4 Single 100 Screw Double Top Plate Complete With Truss And Long Leg Multigrip - Stud to Wall Plate connection

Pryda Screw used with Long-Leg MultiGrip

Pryda Screw Heads for Stud to Wall Plate connection

All screws are head stamped to ensure quality and instant identification